Repairs & Alterations
New Tip
Buffalo Plus - £10
Elkmaster - £10
ADR147 Laminate - £16
Taylor Made - £13
Mike Wooldridge Supertip - £16
The old tip is removed and the ferrule is then faced off on the lathe for a perfectly flat surface in preparation for the new tip. The new tip is applied, trimmed and shaped to an even finish. The ferrule is then polished up and the side walls of the tip are burnished.
​
Ferrule Replacement
Brass - £40
Titanium - £60
Buffalo Horn - £50
The old tip and ferrule are removed and a new Tenon is cut into the shaft using the lathe for a precision fitting of the new ferrule. The ferrule is a very tight knock on fit and is reinforced with Epoxy resin to secure it in place. The new tip is fitted and the ferrule is polished. The prices above include fitting of a single layered tip as standard.
Shorten Cue
No Re-taper - £35
Re-taper - £65
The cue is cut to the desired length. A new ferrule and tip is fitted on the lathe and the ferrule is polished. The prices above include fitting of a single layered tip as standard.
Extend Cue
From £100 (depends on woods chosen)
The cue is extended by adding 4 new splices to the butt of the cue. This is done by first adding a dowel of the desired length to the butt of the cue. The dowel and existing cue are then cut in the normal method to prepare for new splices to be added. The new splices of wood as chosen by the customer are then glued on and turned in to a smooth finish. The wedge, badge and butt joint are then added and the cue is finished with oil and wax.
Add a Joint
Standard - from £75
The cue is split at the desired location. A new joint is fitted to the shaft and butt sections ensuring that the grain alignment is maintained.
Split/Broken Cue
From £75
Where possible a split shaft can be repaired. The cue is then refinished and restored to its original playing condition.