All break cues are made using woods to match your playing cue. They are typically the same in length but can be made shorter or longer upon your request. Each one is finished off with my gold plated Karl Craik Customs badge, a Carbon fiber ferrule and a hard break tip (usually a clear glass style tip).
A standard break Cue with a single front splice usually made from Ebony. They can however also be made from a wood to match you cues exotic splices.
The Classic/Envy break cue is made with an Ebony main splice and an additional front splice to match your cues lower exotic splices. It can also include matching veneers.
Also available with a resin upgrade for an extra £30.
The Elite/Prestige break cue is made with an Ebony main splice followed by 2 sets of front splices to match your cues lower exotic splices. It can also include matching veneers.
Also available with a resin upgrade for an extra £60.
The APEX break cue is made with an Ebony main splice followed by 3 sets of front splices to match your cues lower exotic splices. It can also include matching veneers.
Also available with a resin upgrade for an extra £90.
A brass joint can be added at the 3/4 location typically 12" to 16" from the Butt to allow the cue to be split and broken down for easier transport.
Adding a further personalised finishing touch to your cue in a secondary laser engraved acrylic badge. Designed to your own specification in a variety of fonts and colours.
If you prefer a full round butt rather than the traditional Mace/wedge on a cue this can be done by sinking the badge into the cue, filling with a clear epoxy resin and blending it into the natural taper of the cue.
An additional butt joint can be added if required using the same full brass face plate style joint that I use on all of my playing cues.